Steps Necessary To Pass The DEA-41T1 Exam from Training Expert TopExamCollection [Q65-Q89]

Share

Steps Necessary To Pass The DEA-41T1 Exam from Training Expert TopExamCollection

Valid Way To Pass EMC DECA-PowerEdge's  DEA-41T1 Exam

NEW QUESTION 65
Which types of data transfer interface are used by Dell EMC servers to connect mass storage devices?

  • A. Ethernet, SSD, CSI, CSI, and SAS
  • B. USB, Ethernet, SSD, and CSI
  • C. SSD, CSI, USB, and SAS
  • D. SAS USB, Ether, and SSD

Answer: D

 

NEW QUESTION 66
An administrator is scheduling a software patch in an enterprise environment. What is a consideration for the administrator regarding potential impact to users?

  • A. Disruption of workflows
  • B. Update file size
  • C. Server Redundancy
  • D. Network Bandwidth

Answer: A

 

NEW QUESTION 67
What is the Dell EMC iSM?

  • A. Program that is installed and provides one-to-one systems management functionality
  • B. Agent that expands iDRAC management functionality into the host operating system
  • C. Systems management console that simplifies monitoring of multiple Dell EMC servers
  • D. Out-of-band management platform on Dell EMC servers

Answer: B

Explanation:
Explanation/Reference: https://www.dell.com/support/article/pk/en/pkbsd1/sln310557/dell-emc-idrac-service-module?
lang=en

 

NEW QUESTION 68
Which key is used to access the one-time boot menu when preparing a Dell EMC PowerEdge server?

  • A. F12
  • B. F2
  • C. F10
  • D. F11

Answer: A

 

NEW QUESTION 69
Where are the system settings of a Dell EMC PowerEdge server stored?

  • A. vFlash
  • B. CMOS
  • C. UEFI
  • D. BIOS

Answer: D

 

NEW QUESTION 70
An administrator needs to set up a RAID which requires high performance but no data protection.
Which RAID level fulfills these requirements?

  • A. RAID 0
  • B. RAID 1
  • C. RAID 6
  • D. RAID 5

Answer: A

Explanation:
Explanation
RAID 0 provides somewhat better performance than 5 or 1/10 but offers no data protection. In larger transfer size environments, RAID 1/10 performances can be slightly better than RAID 5 but has a much higher disk- cost.

 

NEW QUESTION 71
An administrator has been tasked with installing a server with greater than 2TB partition.
Which boot mode would allow this?

  • A. BIOS
  • B. UEFI
  • C. GRUB
  • D. GUID

Answer: B

 

NEW QUESTION 72
What is the primary reason for a server emitting a greater heat load than a client system?

  • A. Higher temperature in the data center
  • B. Smaller system fans in the servers
  • C. Less space for air to circulate inside the server chassis
  • D. Increased power usage of the server components

Answer: B

 

NEW QUESTION 73
A system administrator needs to configure their Dell EMC PowerEdge server for PXE boot in UEFI mode.
What is the correct order of steps to accomplish this?

Answer:

Explanation:

 

NEW QUESTION 74
A PowerEdge 14G server administrator has to shut down a server for urgent intervention. They don't want to risk any data loss but don't know the OS password.
What steps should be taken?

  • A. Connect to Lifecycle Controller > Server management > Power Off System
  • B. Connect to iDRAC > Dashboard tab > click Graceful Shutdown
  • C. Connect to Lifecycle Controller > Server management > Send OS shutdown command
  • D. Connect to iDRAC > Dashboard tab > click Power Off System in the dropdown menu

Answer: A

 

NEW QUESTION 75
Refer to the exhibit.

An administrator has a standalone M1000e chassis with only a single CMC module. The CAT6 cable is plugged into the Ethernet port closest to the DB-9 connector. The power indicator light is lit but the administrator is unable to access the CMC module.
What could be the cause of this issue?

  • A. CAT6 cable into the stacking port
  • B. No DB-9 serial cable is plugged in
  • C. CAT5 cable is required for connection to CMC
  • D. CMC module was removed without powering off the chassis

Answer: B

Explanation:
Explanation/Reference: https://topics-cdn.dell.com/pdf/poweredge-m1000e_owners-manual_en-us.pdf

 

NEW QUESTION 76
A server administrator needs to monitor a Dell EMC PowerEdge server without installing any additional software. Which management tool is the most appropriate to use?

  • A. OME
  • B. iDRAC
  • C. OMSA
  • D. SAE

Answer: A

 

NEW QUESTION 77
What is an statement in reference to software RAID?

  • A. Software RAID requires a hardware license
  • B. Software RAID does not have any data integrity issues
  • C. Software RAID uses CPU resources
  • D. Software RAID is an additional cost

Answer: C

 

NEW QUESTION 78
Where in the iDRAC GUI can the recording of the last three boot cycles of a Dell EMC PowerEdge server be found?

  • A. Troubleshooting > SupportAssist
  • B. Maintenance > Diagnostics
  • C. Troubleshooting > Lifecycle Log
  • D. Maintenance > Troubleshooting

Answer: D

Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/poweredge-r540/idrac_3.30.30.30_ug/viewing-boot- and-crash-capture-videos?guid=guid-56ced8f4-162d-4329-ab95-169445213eae&lang=en-us

 

NEW QUESTION 79
What benefit is offered by modular servers over rack servers?

  • A. Higher density is achieved by reducing the amount of consumed rack space
  • B. Lower power requirements result in lower datacenter operating costs.
  • C. Hot replacement of any server in the enclosure is possible
  • D. All hardware technology is integrated into a single circuit board

Answer: A

Explanation:
Explanation/Reference: https://www.racksolutions.com/news/data-center-optimization/blade-server-vs-rack-server/

 

NEW QUESTION 80
A system administrator notices that a client system cannot access the internet. The IPaddress is 169.254.10.26.
The cline system is correctly wired. Which server role should the administrator investigate?

  • A. TCPMP
  • B. PROXY
  • C. DHCP
  • D. SNMP

Answer: C

 

NEW QUESTION 81
What distinguishes server CPUs from client CPUs?

  • A. Server CPUs have no overlocking features; client CPUs do have them
  • B. Server CPUs frequently have fewer cores and more processing power than client CPUs
  • C. Servers tend to have fewer CPUs installed than clients
  • D. Server CPUs use identical socket types, client CPUs use multiple socket types

Answer: A

Explanation:
Explanation/Reference: https://www.quora.com/How-can-you-describe-the-difference-between-server-CPU-and-desktop- CPU

 

NEW QUESTION 82
Refer to the exhibit.

An administrator has a standalone M1000e chassis with only a single CMC module. The CAT6 cable is plugged into the Ethernet port closest to the DB-9 connector. The power indicator light is lit but the administrator is unable to access the CMC module.
What could be the cause of this issue?

  • A. CAT6 cable into the stacking port
  • B. No DB-9 serial cable is plugged in
  • C. CAT5 cable is required for connection to CMC
  • D. CMC module was removed without powering off the chassis

Answer: B

Explanation:
Explanation/Reference:
Reference: https://topics-cdn.dell.com/pdf/poweredge-m1000e_owners-manual_en-us.pdf

 

NEW QUESTION 83
What is the maximum bootable storage capacity supported by BIOS mode?

  • A. 512 GB
  • B. 4 TB
  • C. 1 TB
  • D. 2 TB

Answer: D

 

NEW QUESTION 84
A system administrator is installing Hyper-V on a Windows Server 2016. They receive an error message.
How can they solve the problem?

  • A. Ensure minimum memory of 2 GB
  • B. Check the installed processor is x86
  • C. Confirm essentials license is installed
  • D. Verify that the virtualization feature is enabled

Answer: C

 

NEW QUESTION 85
A RAID 5 configuration with 20 hard drives loses one hard drive. How many additional hard drive failures can this configuration tolerate before experiencing data loss?

  • A. 0
  • B. 1
  • C. 2
  • D. 3

Answer: B

Explanation:
Explanation/Reference:
Reference: https://www.prepressure.com/library/technology/raid

 

NEW QUESTION 86
What is s backup process?

  • A. Capturing historical records used for further reference and is not actively used by the server.
  • B. Copying files to a secondary site for preservation in case of equipment failure of other catastrophe.
  • C. Moving data that is no longer activity used to a separate storage device , for long-term retention.
  • D. Using server technologies to transmit data from one computer node to another

Answer: A

 

NEW QUESTION 87
Which initial option should be chosen fromthe iDRAC Virtual Console to access System Setup?

  • A. Virtual CD/DVD
  • B. Next Boot
  • C. Lifecycle Controller
  • D. Normal Boot

Answer: C

 

NEW QUESTION 88
Refer to the exhibit.

What is this system referred to?

  • A. HAC
  • B. CRAH
  • C. HVAC
  • D. FANS

Answer: C

 

NEW QUESTION 89
......

All DEA-41T1 Dumps and Associate - PowerEdge Exam Training Courses: https://www.topexamcollection.com/DEA-41T1-vce-collection.html

Free Test Engine For Associate - PowerEdge Exam Certification Exams: https://drive.google.com/open?id=1IWc2iALCgmqcIsZ5l4trES0lrAKiAUaw