We're so confident of our products that we provide no hassle product exchange.
NACE Coating Inspector Level 2 Sample Questions:
1. You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner's representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?
A) SP 1 followed by caustic etching
B) SP 1 followed by SP 2
C) SP 1 followed by acid etching
D) SP 1 followed by SP 3
2. The coating applicator has ignored a enface preparation hold point and applied coating over the surface without a sign off from you as the inspector.
Your FIRST preferred course of action is to:
A) Advise the Owner and write a Non-Conformance report
B) Stop the job
C) Require the Applicator to remove the coating
D) Ignore the situation
3. When working with someone who is very concerned about Stability and maintaining adherence to the status-quo, the Inspector should try to:
A) Implement immediate to get them motivated
B) Give them as much advance notice as possible about upcoming changes
C) Make sure they are the center of attention in all site meetings
D) Challenge their value to the team and try to get them out of their comfort zone
4. Antifouling coatings are regulated by international treaties.
A) True
B) False
5. When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:
A) Tooke Gauge
B) Ultra Sonic DFT Gauge
C) Eddy Current Gauge
D) Magnetic Gauge
Solutions:
| Question # 1 Answer: B | Question # 2 Answer: C | Question # 3 Answer: B | Question # 4 Answer: A | Question # 5 Answer: A |
By Stan
