We're so confident of our products that we provide no hassle product exchange.
EMC Symmetrix Solutions Specialist Exam for Technology Architects Sample Questions:
1. In an Open Replicator solution what do the terms HOT and COLD refer to?
A) The state of the Remote device
B) The state of the Source device
C) The state of the Target device
D) The state of the Control device
2. After the tracks are synchronized between R1 and R2 devices, how many cycle-switches should occur for R2 to become consistent with R1, when you change RDF mode from ACP_DISK to ASYNC?
A) Four
B) One
C) Two
D) Three
3. What is the status of the R1 and R2 devices after performing an SRDF failover operation?
A) R1 Write Disabled; R2 Read/Write
B) R1 Read/Write; R2 Read/Write
C) R1 and R2 Not Ready
D) R1 Read/Write; R2 Write Disabled
4. What is a reason to preallocate space when binding thin devices?
A) To prevent back-end disk contention
B) To maximize striping of data over all data devices
C) To allow load balancing of host I/O
D) To improve performance in thin hostile environments
5. Which configuration is necessary for a host to use Enginuity Consistency Assist (ECA) to perform TimeFinder/Snap consistent activation?
A) PowerPath must be installed on the host
B) A dedicated channel to the virtual devices
C) A dedicated channel to the gatekeeper devices
D) PowerPath must be invoked with the -cg option
Solutions:
| Question # 1 Answer: D | Question # 2 Answer: C | Question # 3 Answer: A | Question # 4 Answer: D | Question # 5 Answer: C |
By Brandon
