Citrix NetScaler 10 Essentials and Networking Sample Questions:
1. A network engineer needs to configure smart card-based authentication on NetScaler Access Gateway.
Which type of authentication policy could the engineer configure in order to accomplish this task?
A) Secure LDAP
B) Local
C) Certificate
D) RADIUS
2. Scenario: A NetScaler engineer needs to enable access to some web servers running on an IPv6only network. The clients connecting the services are on an IPv4 network. The engineer has already enabled IPv6 on the NetScaler.
What does the engineer need to do in order to provide access to the services on the IPv6 network?
A) Create an IPv6 tunnel and a IPv4 virtual server.
B) Create an IPv6 ACL and a IPv4 virtual server and bind the ACL to the virtual server.
C) Configure an IPv6 VLAN and bind the required interface.
D) Create a IPv4 virtual server and bind the service group to it.
3. Scenario: A network engineer needs to implement high availability (HA) for a pair of NetScaler appliances. The existing appliance was recently restarted and the new appliance has been rack mounted and turned on for several weeks waiting to be configured. The engineer needs to create an HA pair, but is concerned that his original appliance will get erased when the HA pair is created.
Which two tasks could the engineer do before the creation of the HA pair to ensure that the exiting unit stays the main appliance? (Choose two.)
A) Enable HA Sync before adding the second node.
B) Configure StaySecondary on the new node.
C) Create a Route Monitor to ensure proper synchronization.
D) Ensure that INC mode is enabled during creation of HA Pair.
E) Set StayPrimary on the existing node.
4. The disk is full on a NetScaler appliance but NO alerts were generated by the SNMP traps.
What is the likely cause of this failed alert?
A) Auditing is not enabled.
B) Health monitoring has not been enabled.
C) EdgeSight monitoring is not configured.
D) The threshold was not set for the alarm.
5. Scenario: A network engineer created an SSL virtual server and enabled smart card on it. The engineer tried browsing to the server and noticed the back-end system could NOT see the users certificates.
What could be causing this issue?
A) The SSL virtual server cannot forward a client certificate.
B) The network engineer has not enabled SNI on the virtual server.
C) The network engineer has not set smart card to mandatory.
D) The network engineer forgot to enable the SSL policy allowing smart card forwarding on the SSL virtual server.
E) The SSL virtual server cannot use smart card authentication.
Solutions:
| Question # 1 Answer: C | Question # 2 Answer: D | Question # 3 Answer: B,E | Question # 4 Answer: D | Question # 5 Answer: A |

We're so confident of our products that we provide no hassle product exchange.


By Sam


